LoadingComments and suggestions
Hello, dear friends! My name is Dmitriy or just Dima :) I'm the creator of the ModelMen.ru site, I did it specifically to collect the most interesting ideas and handicrafts created by myself.
I like to create and I seek the same people who are ready to do the same as I do ;)
One I can create a lot, but together with you we can more, share your impressions, ideas, tell us what would you like to see on the 1000DIY.com website?
Suggestions leave comments below
Add comment
Random DIY
-
Today, instead of round guides, the printer received square, using a conventional aluminum profile tube with a cross section of 20 * 20 mm. Bearings roll along the pipe 623zz. All plastic parts were printed on the same printer before it was altered. -
Almost all toys bought for the daughter do not cause the child's interest, which can not be said about developing toys made by themselves. Below is a photo of the simplest developing mat, which the wife made for a couple of evenings from old buttons. -
I made this powerful lawnmower myself for the village, there is always a lot of high grass, which is not rational to fight with the usual manual trimmer. This animal mows down everything, tough grass, small trees, levels of hills, covered with moles, and even turns old bricks out of the ground. -
I present to your attention a homemade 3d printer. Assembled from plywood, aluminum, plastic and Arduino. This printer is unique in that its kinematics is peeped from Ultimaker, but done with quality modifications. -
Candles in the shape of eggs perfectly complement the Easter holiday. The unusual shape of the candle very much like the grandmother.
